HP P9000 Command View Advanced Edition Software Mainframe Agent Installation and Configuration Guide

Figure 11 Operating procedure for changing the configuration of P9000 mainframe agent
To change the configuration of P9000 mainframe agent:
1. Stop information collection by Device Manager.
2. Stop P9000 mainframe agent.
see “Stopping P9000 mainframe agent” on page 65.
3. Correct the initialization parameter.
see “Creating initialization parameters” on page 31.
4. Start P9000 mainframe agent.
see “Starting P9000 mainframe agent” on page 64.
5. Restart information collection by Device Manager.
Using Replication Manager software to monitor PPRC copy
pairs
This section describes how to use Replication Manager software to monitor PPRC copy pairs.
Operation overview
When a request for information from Replication Manager software is received, the following PPRC
copy pair information is provided by Replication Manager software, based on the P9000 mainframe
agent:
• Host volume information
• Copy group definition information
• Statuses of copy pairs defined in the copy group
The following figure shows how Replication Manager software monitors PPRC copy pairs.
Mainframe Agent Installation and Configuration Guide 51