HP P9000 Command View Advanced Edition Software Mainframe Agent Installation and Configuration Guide

When you execute the command, specify the following parameters:
objectid: Specify the object ID of the mainframe host that was output when the mainframe host
was registered using the AddHost command.
Action to be taken if an error occurs during the execution of the AddHostRefresh command:
1. Check whether P9000 mainframe agent is operating normally.
If it is not operating normally, check the P9000 mainframe agent settings, and restart P9000
mainframe agent.
2. Check whether the mainframe host and P9000 mainframe agent are registered correctly.
If they are registered correctly, use the AddHostRefresh command to acquire the mainframe
storage information again. If they are not registered correctly, register them correctly using
the procedures described in section “Registering the mainframe host in Device
Manager” on page 43 or “Registering the P9000 mainframe agent running on the mainframe
host” on page 43.
Command format:
hdvmcli AddHostRefresh "objectid=mainframe-host-object-ID"
Example of executing the command:
hdvmcli AddHostRefresh -o "D:\logs\AddHostRefresh.log" "objectid=HOST.1"
Refreshing mainframe storage information
To refresh the mainframe storage information displayed in GUI, use the AddHostRefresh command.
This command is the only means of refreshing the mainframe storage information.
When you execute the command, specify the following parameter:
objectid: Specify the object ID of the mainframe host that was output when the mainframe host
was registered using the AddHost command.
Action to be taken if an error occurs during the execution of the AddHostRefresh command:
1. Check whether P9000 mainframe agent is operating normally.
If it is not operating normally, check the P9000 mainframe agent settings, and restart P9000
mainframe agent.
2. Check whether the mainframe host and P9000 mainframe agent are registered correctly.
If they are registered correctly, use the AddHostRefresh command to acquire the mainframe
storage information again. If they are not registered correctly, register them correctly using
the procedures described in “Registering the mainframe host in Device Manager” on page 43
or “Registering the P9000 mainframe agent running on the mainframe host” on page 43.
Command format:
hdvmcli AddHostRefresh "objectid=mainframe-host-object-ID"
Example of executing the command:
Mainframe Agent Installation and Configuration Guide 45