HP P9000 Command View Advanced Edition Software Mainframe Agent Installation and Configuration Guide

Description of directive, and values to be specifiedDirective to be specified

Specify the following options to set up P9000 mainframe agent to act as the

origin server for Device Manager or Replication Manager software:

• The host name or IPv4 address of the host that is running P9000 mainframe

agent

• The port number that was specified for the PORT parameter when initially

setting up P9000 mainframe agent

The following example shows how to specify the options:

ProxyPass / http://host-name-or-IPv4-address:port-number

/ProxyPassReverse / http://

host-name-or-IPv4-address:port-number/

ProxyPass and Proxy-

PassReverse

This directive is used to specify how long to wait before issuing a timeout.

Specify a value greater than the timeout values of Replication Manager

software (bcmif.socketTimeout) and Device Manager

(host.mf.agent.connection.timeout).

Timeout

Collecting the trace log

To collect error logs and access logs between either Device Manager or Replication Manager software

and IBM HTTP Server, use the log function of IBM HTTP Server.

As for whether to collect logs of IBM HTTP Server, follow the instruction from the Web administrator.

Note that, if you do not collect logs, it might be difficult to determine the cause of an access error.

Creating initialization parameters

This section describes how to create the initialization parameters for setting up the environment that

is required to start the P9000 mainframe agent. YKPRM00 is a member of the initialization parameter

samples registered in the sample library during initialization. Adjust the parameters to fit your

environment.

Create a dataset to hold the initialization parameters by specifying the following attributes:

• LRECL: 80

• BLKSIZE: Multiple of 80

• RECFM: Fixed-length or blocked fixed-length record

• DSORG: Sequential or partitioned dataset

How to use the SETINIT command

This subsection explains the format of the SETINIT command, that sets the initialization parameters.

For details about the symbols used in command explanations, see Table 25. For details about the

command syntax elements, see Table 26.

SETINIT[

parameter]...

Specify a SETINIT command and parameters in columns 1 through 71. Any information specified

in a column after column 72 is ignored.

Mainframe Agent Installation and Configuration Guide 31