HP P9000 Command View Advanced Edition Software Mainframe Agent Installation and Configuration Guide

Parameters
SVC-number ~ <numeric characters> ((200 to 255))
Specifies an SVC number to assign to a user SVC.
DELETE
Specified to delete a user SVC.
If you omit the optional PARM= part of the command, an unused SVC number between 200 and
255 is assigned.
Return codes
Used to indicate task status, as shown in the following table.
Table 4 YKALCSVC command return codes list
MeaningReturn code
The command ended normally.
0
The SVC number is already registered.
4
Registration or deletion of the SVC number failed.
16
Processing stopped due to an error (the specified value or execution environ-
ment is invalid).
20
Registering a user SVC
You must use one of the following methods to register the user SVC:
• Registration using the IEASVCxx parmlib member
• Registration using the YKALCSVC command
If you use the IEASVCxx parmlib member to perform registration, you must reload the system (that
is, perform an initial program load (IPL)). If you are unable to perform an IPL while the system is
running, use the YKALCSVC command to perform registration.
CAUTION:
When HP StorageWorks P9000 for Business Continuity Manager Software is installed, do not register
a user SVC.
Using IEASVCxx parmlib member to register
To register the user SVC:
(For details on steps 2 and 4, see MVS Initialization and Tuning Reference.)
1. Choose a number between 200 and 255 to assign to the user SVC.
Installing P9000 mainframe agent22