HP P9000 Command View Advanced Edition Software Mainframe Agent Installation and Configuration Guide
secondary site A site with a recovery host and a storage system in a 2DC configuration. This
is the destination for backup copies. To prevent both hosts from stopping
simultaneously during a disaster, it should be some hundreds to some thousands
of kilometers away from the primary host.
serial number of
storage system
In XP1024/XP128 Seriess and XP12000/XP10000/SVS200, a serial number
of storage system is a number assigned to each storage system (physical DKC
serial number). In XP24000/XP20000 and HP StorageWorks P9500, a serial
number of storage system is a number assigned to each logical disk controller
(logical DKC serial number)
SETINIT
command
A command used to set the initialization parameter for the P9000 mainframe
agent. By specifying this parameter in the MODIFY command, you can
dynamically change the log output level.
START command An operator command used to start P9000 mainframe agent.
STOP command An operator command used to stop P9000 mainframe agent.
suspend status A collective name for the SUSPOP status, SUSPCU status and, SUSPER status.
Synchronous copy
pair
A function that creates and manages remote copies of volumes between storage
systems. This writes a copy pair to the S-VOL synchronously with the P-VOL.
VOLSER A volume serial number used by a mainframe host to manage storage volumes.
YKAGALLO job A job that assigns datasets required before installation of P9000 mainframe
agent.
YKAGENTD An executable program of the P9000 mainframe agent. This is also the name
of the standard startup cataloged procedure of the P9000 mainframe agent.
YKAGINST job A job that installs P9000 mainframe agent.
YKALCSVC
command
A command used for registering the user SVC required for running P9000
mainframe agent. This command is started by the OS START command.
YKP2A command A command used to generate configuration files, which are used to monitor PPRC
copy pairs.
YKPRM00 A member to which an initialization parameter (required to run the P9000
mainframe agent) is registered.
Mainframe Agent Installation and Configuration Guide 113