HP XP P9000 for Business Continuity Manager Software Installation Guide

The following shows an example of specifying the settings shown in Table 31 (page 69) for
initialization parameters.
SETINIT PORT(24042)
SETINIT MODE(EDIT)
SETINIT LOCK(PREFIX)
/* PREFIX */
SETINIT PREFIX('ACCOUNT','NY', 'ROUTE1',’*’,'LA')
SETINIT PREFIX('INFO','NY','ROUTE2','NY2','LA')
For Business Continuity Manager agent on local and remote sites
When Business Continuity Manager agent is on both the local and remote sites, configure the
Business Continuity Manager agent on each site to perform a scan on that site, only.
Figure 12 Example configuration when Business Continuity Manager agent is on the local site and
a remote site
For the configuration shown in Figure 12 (page 70), specify the settings listed in Table 32 (page 71)
to connect Business Continuity Manager agent to the Replication Manager installed on each site.
70 Setting up the environment when linking with XP P9000 Replication Manager