HP XP P9000 for Business Continuity Manager Software Installation Guide

ManualsBrandsHP ManualsSoftwareHP XP P9000 Auto LUN Software

[

MODE(startup-mode)]

[

LOCK(lock-mode)]PORT(port-number)]

[RECVWAITTIME(reception-wait-time)]

[HOSTNAME('host-identification-name')]

[PREFIX('prefix','local-site's-DAD-ID'[,'route-list-ID[,{routelabel|*}]'[,['local-site's-Non-Gen'ed-DAD-ID'][,'remote-site's-DAD-ID']]])]

[DEVN(start-device-number,end-device-number)]

[LOGLEVEL(output-level)]

[AUDITLOG(SYSMLOG)]

[MODE(startup-mode)]

[LOCK(lock-mode)]

Parameters

PORT(port-number) ~ <numeric characters> ((1-65535)) <<24042>>

Specifies the Business Continuity Manager agent port for TCP/IP communication with Replication

Manager. You cannot specify a port number that is being used by another job. Specify a port

number that is not being used in the system.

RECVWAITTIME(reception-wait-time) ~ <numeric characters> ((0-65535)) <<180>>

When TCP/IP communication with Replication Manager is performed, this parameter specifies

the wait time (in seconds) from when a receive request is initiated to when data is received. A

value of 0 means that the Business Continuity Manager agent is to wait for data indefinitely.

HOSTNAME('host-identification-name')~ <1 to 50 alphanumeric characters> <<value

specified for the &SYSNAME system symbol>>

Specify this parameter when Replication Manager needs to identify the Business Continuity

Manager agent. When the Business Continuity Manager agent is running on more than one

host, and a HOSTNAME (host identification name) value is duplicated in these hosts, Replication

Manager cannot identify the host on which the target Business Continuity Manager agent is

running. To ensure that Replication Manager can identify the host on which the Business

Continuity Manager agent is running, specify a unique HOSTNAME value for each host.

When this parameter is omitted, the value of the &SYSNAME system symbol is assumed. For

details about the &SYSNAME system symbol, refer to the MVS Initialization and Tuning Reference.

When the Business Continuity Manager agent runs on more than one host and an &SYSNAME

system symbol value is duplicated in these hosts, Replication Manager cannot distinguish

between the hosts. When the &SYSNAME system symbol value is duplicated, make sure that

HOSTNAME values are unique among the hosts.

PREFIX

('prefix','local-site's-DAD-ID'[,'route-list-ID[,{route-label|*}'[,['local-site's-Non-Gen'ed-DAD-ID'][,'remote-site's-DAD-ID']]])

To enable Replication Manager to manipulate the Business Continuity Manager agent, the

prefix of the configuration files managed by Business Continuity Manager must be specified.

You can specify multiple PREFIX parameters. Specify multiple PREFIX parameters when the

storage information to be acquired is information registered in multiple configuration files that

have different prefixes, in an environment where Replication Manager and the Business

Continuity Manager agent are one-to-one.

prefix ~ <PREFIX string consisting of 1 to 16 characters>

Specifies the file name prefix of the Business Continuity Manager configuration files that

are used by Replication Manager. Specify the value that was specified in Configuration

File Prefix in Business Continuity Manager's Set Defaults panel when the configuration file

was created. Replication Manager can use the disk configuration definition file and the

copy group definition file with the prefix specified here. For details about the Set Defaults

panel in Business Continuity Manager, see the HP Business Continuity Manager Software

Reference Guide.

64 Setting up the environment when linking with XP P9000 Replication Manager