HP XP P9000 for Business Continuity Manager Software Installation Guide

To configure the environment settings in an existing environment:
1. Upgrade Business Continuity Manager. For details, see “Upgrading Business Continuity
Manager” (page 42).
2. Create configuration file datasets. These datasets are needed to perform a device scan and
set copy group definitions in XP P9000 Replication Manager for the first time. Create datasets
for the following configuration files:
• Disk configuration definition file
• Copy group definition file
For details, see “Creating configuration file datasets” (page 53).
3. Configure the environment settings for the Business Continuity Manager agent. For details,
see the following sections:
• “Setting the TCP/IP port number” (page 54)
• “Setting up the security for Business Continuity Manager agents” (page 55)
• “Setting up IBM HTTP Server” (page 56)
• “Creating initialization parameters” (page 61)
• “Creating a cataloged procedure for startup for the Business Continuity Manager agents”
(page 72)
4. Start IBM HTTP Server.
5. Start the Business Continuity Manager agent. For details, see the chapter about linking the
Business Continuity Manager agent with XP P9000 Replication Manager in the HP XP P9000
for Business Continuity Manager Software User Guide.
6. Configure the XP P9000 Replication Manager initialization settings. For details, see the HP
XP P9000 Replication Manager User Guide.
Configuring the environment settings to allow only monitoring of copy groups
Figure 7 (page 52) shows the general procedure for configuring the environment settings in an
existing environment to allow only monitoring of copy groups, without allowing copy groups to
be defined or copy group operations to be performed.
Figure 7 Configuring the environment settings to allow only monitoring of copy groups
To configure the environment settings to allow only monitoring of copy groups:
52 Setting up the environment when linking with XP P9000 Replication Manager