HP XP P9000 for Business Continuity Manager Software Installation Guide

Figure 5 Configuring the environment settings using the Remote DKC Control function (before
Business Continuity Manager is installed)
To configure the environment settings using the Remote DKC Control function:
1. Set up the storage system.
For details, see the HP XP P9000 for Business Continuity Manager Software User Guide.
2. Install Business Continuity Manager.
For details, see “Installing Business Continuity Manager” (page 20).
3. Perform a local scan.
Perform a local scan to create the disk configuration definition file needed for setting the route
list definitions.
For details, see the description about using a local scan to acquire storage system information
in the HP XP P9000 for Business Continuity Manager Software User Guide.
4. Configure the environment settings for the Remote DKC Control function.
Configure the following settings:
• Route list definitions
• Command device registrations
For details, see the HP XP P9000 for Business Continuity Manager Software User Guide.
50 Setting up the environment when linking with XP P9000 Replication Manager