HP XP P9000 for Business Continuity Manager Software Installation Guide

1. Set up the storage system. For details, see the HP XP P9000 for Business Continuity Manager
Software User Guide.
2. Create configuration file datasets. Create datasets for the following configuration files:
• Disk configuration definition file
• Copy group definition file
For details, see “Creating configuration file datasets” (page 53).
3. Install BCM. For details, see “Installing Business Continuity Manager” (page 13).
4. Configure the environment settings for the BCM agent. For details, see the following sections:
• “Setting the TCP/IP port number” (page 54)
• “Setting up the security for Business Continuity Manager agents” (page 55)
• “Setting up IBM HTTP Server” (page 56)
• “Creating initialization parameters” (page 61)
• “Creating a cataloged procedure for startup for the Business Continuity Manager agents”
(page 72)
5. Start IBM HTTP Server.
6. Start the BCM agent. For details, see the chapter about linking the BCM agent to XP P9000
Replication Manager in the HP XP P9000 for Business Continuity Manager Software User
Guide.
7. Configure the XP P9000 Replication Manager initialization settings. For details, see the HP
XP P9000 Replication Manager Software Configuration Guide.
Configuring the environment settings using the Remote DKC Control function (before
Business Continuity Manager is installed)
Figure 5 (page 50) shows the general procedure for configuring the environment settings starting
from before installation of Business Continuity Manager, using the Remote DKC Control function.
Overview of environment settings 49