HP XP P9000 for Business Continuity Manager Software Installation Guide

TIP: The following describes how to check the environment setting values that are currently valid
in the system.
• If Business Continuity Manager has been installed (upgrade):
Check the environment setting values you obtained during the check before upgrading. For
details, see “Deleting the user SVC” (page 44) in “Pre-upgrade procedure” (page 44).
• If Business Continuity Manager has not been installed (new installation):
Use the KTDSPENV command of Tiered Storage Manager for Mainframe to check the values.
For details on the KTDSPENV command, see the HP Tiered Storage Manager for Mainframe
User Guide.
User SVC versions required by Business Continuity Manager
The following table lists the versions of user SVCs that are required in each version of Business
Continuity Manager.
Table 23 User SVC versions required by Business Continuity Manager
User SVC version requiredVersion of Business Continuity Manager
03-00 and later03-00
04-00 and later04-00
04-01 and later04-01
04-02 and later04-02
05-00 and later05-00
05-01 and later05-01
05-02 and later05-02
05-03 and later05-03
05-05 and later05-05
05-06 and later05-06
06-00 and later06-00
06-10 and later06-10
6.2.0 and later6.2.0
6.3.0 and later6.3.0 to 6.6.0
6.6.1 and later6.6.1
6.7.0 and later6.7.0 to 6.7.1
7.3.0
7.4.0 and later7.4.0
7.5.0 and later7.5.0
7.6.0
User SVC versions required by Business Continuity Manager 47