HP XP P9000 for Business Continuity Manager Software Installation Guide

Parameters For the host ID, specify a value that is
unique among hosts (operating systems).
YKCMDIF=[host-id] ~ <2-digit
hexadecimals> ((00 to 1F))
The specified value for the host ID is given
priority over the &YKCMDIF system symbol
in the IEASYMxx parmlib member. If this
command is executed with the host ID
omitted (PARM='YKCMDIF=' is specified),
the value of the &YKCMDIF system symbol
will be used.
YKLCNSE=[prefix1] ~ <8 or fewer
alphanumeric characters>
Specify a prefix1 for the license
information dataset so that the name of
the dataset is unique. If the prefix1 is
omitted, specify PARM='YKLCNSE='.
For details about the prefix1 for the
license information dataset, see section
“Naming for license information datasets”
(page 40).
YKLCNS2=[prefix2] ~ <8 or fewer
alphanumeric characters>
Specify a prefix2 for the license
information dataset so that the name of
the dataset is unique. If the prefix2 is
omitted, specify PARM='YKLCNS2='.
For details about the prefix2 for the
license information dataset, see section
“Naming for license information datasets”
(page 40).
LOGPUT=[LOGR | SAM] Specify whether or not the system logger service
is to be used, when outputting BCM logs.
The specified value for the LOGPUT parameter is
given priority over the &YKLOGPT system symbol
in the IEASYMxx parmlib member. If this
command is executed with the LOGPUT parameter
omitted (PARM='LOGPUT=' is specified), the
value of the &YKLOGPT system symbol will be
used.
LOGR: BCM logs are output using the system
logger service.
SAM: BCM logs are output to sequential datasets.
SYSLOG=[YES | CONSOLE | NO] Specify whether or not CLI
command-execution logs are output to
SYSLOG or the console.
The value specified for the SYSLOG
parameter is given priority over the
&YKSYSLG system symbol in the
IEASYMxx parmlib member. If this
command is executed with the SYSLOG
parameter omitted (PARM='SYSLOG=' is
specified), the value of the &YKSYSLG
system symbol will be used.
YES: CLI command-execution logs are
output to SYSLOG.
Setting up the environment 35