HP XP P9000 for Business Continuity Manager Software Installation Guide

Table 10 Amount of Business Continuity Manager log data when the system logger service is not used
Items per commandSize
1
Type of Business Continuity Manager log
data
number-of-messages-output100 +
message-length
2
Messages (excluding those output from the
ISPF panel, or scripts)
number-of-times-an-
I/O-error-occurred
100 + CCW-length
3
Parameter information for the channel
command words of the I/O, only when an
I/O error occurs
number-of-times-an-
I/O-error-occurred
256I/O return information, only when an I/O
error occurs
number-of-times-an-
I/O-error-occurred
256Sense byte information, only when an I/O
error occurs
2128Timestamps
1256Command parameter information
1
Business Continuity Manager logs are output with a specified value of this size, rounded up by a factor of 32.
2
The maximum message length is 256 bytes.
3
This is 2,051 bytes when the copy pair status is obtained, and 256 bytes or less otherwise.
When the system logger service is used
Table 11 (page 17) shows the amount of log data output when the system logger service is used
for Business Continuity Manager log output (for LOGPUT=LOGR).
Table 11 Amount of log data output when system logger service is used
Items per commandSize
1
Type of Business Continuity Manager log
data
number-of-messages-output68 +
message-length
2
Messages (excluding those output from the
ISPF panel, or scripts)
number-of-times-an-
I/O-error-occurred
68 + CCW-length
3
Parameter information for the channel
command words of the I/O, only when an
I/O error occurs
number-of-times-an-
I/O-error-occurred
224I/O return information, only when an I/O
error occurs
number-of-times-an-
I/O-error-occurred
224Sense byte information, only when an I/O
error occurs
296Timestamps
1224Command parameter information
Preparing for installation 17