HP StorageWorks P9000 Mainframe Host Attachment and Operations Guide: P9500 Disk Array (AV400-96332, January 2011)
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset |
| F6=Previous F7=Backward F8=Forward F9=Swap F12=Cancel |
'-----------------------------------------------------------------------------'
| F6=Previous F7=Backward F8=Forward F9=Swap F12=Cancel |
'-----------------------------------------------------------------------------'
7. On the Add Control Unit panel, enter CHPIDs that attach to the control unit, the control unit
address, the device starting address, and the number of devices supported, and then press
Enter.
Goto Filter Backup Query Help
.--------------------------- Add Control Unit ----------------------------.
| |
| |
| Specify or revise the following values. |
| |
| Control unit number . : 8000 Type . . . . . . : 2105 |
| Processor ID . . . . . : PROD |
| |
| Channel path IDs . . . . 60 61 62 63 64 65 66 67 + |
| Link address . . . . . . __ __ __ __ __ __ __ __ + |
| |
| Unit address . . . . . . 00 __ __ __ __ __ __ __ + |
| Number of units . . . . 256 ___ ___ ___ ___ ___ ___ ___ |
| |
| Logical address . . . . 0_ + (same as CUADD) |
| |
| Protocol . . . . . . . . __ + (D,S or S4) |
| I/O concurrency level . 2 + (1, 2 or 3) |
| |
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset F9=Swap |
| F12=Cancel |
'-------------------------------------------------------------------------'
8. Verify that the data is correct on the Select Processor / Control Unit panel, and then press F3.
Goto Filter Backup Query Help
.---------------------- Select Processor / Control Unit ----------------------.
| Row 1 of 1 More: > |
| Command ===> ___________________________________________ Scroll ===> PAGE |
| |
| Select processors to change CU/processor parameters, then press Enter. |
| |
| Control unit number . . : 8000 Control unit type . . . : 2105 |
| |
| Log. Addr. -------Channel Path ID . Link Address + ------- |
| / Proc. ID Att. (CUADD) + 1---- 2---- 3---- 4---- 5---- 6---- 7---- 8---- |
| _ PROD Yes 0 60 61 62 63 64 65 66 67 |
| ***************************** Bottom of data ****************************** |
| |
| |
| |
| |
| |
| |
| |
| |
| F1=Help F2=Split F3=Exit F4=Prompt F5=Reset |
| F6=Previous F7=Backward F8=Forward F9=Swap F12=Cancel |
'-----------------------------------------------------------------------------'
9. On the Control Unit List panel, add devices to the new Control Unit, input an S next to CU
8000, and then press Enter.
Goto Filter Backup Query Help
--------------------------------------------------------------------------
Control Unit List Row 40 of 41
Command ===> ___________________________________________ Scroll ===> PAGE
Select one or more control units, then press Enter. To add, use F11.
/ CU Type + Serial-# + Description
_ 7001 3990 __________ ________________________________
S 8000 2105 __________ add 2105 type for 80xx devices
******************************* Bottom of data ********************************
F1=Help F2=Split F3=Exit F4=Prompt F5=Reset F7=Backward
F8=Forward F9=Swap F10=Actions F11=Add F12=Cancel
Mainframe hardware definition 25