HP XP7 Replication Manager Configuration Guide (TK981-96012, May 2014)

6. In the Cluster Administrator window, right-click the group in which the HDvM service
(DeviceManagerServer) is registered, and choose Move Group to switch the node to the executing
node.
7. In the Cluster Administrator window, right-click the group in which the HDvM service
(DeviceManagerServer) is registered, and choose Online.
Using the hcmds64dbclustersetup command
If there are no XP7 Command View AE products in a cluster configuration on the same host, execute
the command shown below. This command changes the port number of the port used by HiRDB to
the default port number (22032). If you changed the port number to a number other than the default,
note the port number being used so that you can specify it later.
Common-Component-installation-folder\bin\hcmds64dbclustersetup /
createcluster /databasepath database-re-creation-folder /exportpath
target-folder-for-storing-database /auto
For database-re-creation-folder, specify a folder on the shared disk. For
target-folder-for-storing-database, specify a folder on the local disk. (Before executing
the command, be sure to delete or empty these folders of any existing files. After executing
hcmds64dbclustersetup, the port number of the port used by HiRDB will be changed to the
default (22032)). The storage folder on the shared disk must have free space greater than the total
volume of the databases.
NOTE:
For database-re-creation-folder on the shared disk, the required space is the sum of the following:
• Database capacity of XP7 Command View AE Common Component
• Database capacity of all XP7 Command View AE products (including Replication Manager) that
are installed on the host where Replication Manager is installed
If the hcmds64dbclustersetup command fails because there is not enough space, increase the
space for that folder and re-execute the command.
Do not disconnect the shared disk from the executing node until the hcmds64dbclustersetup
command terminates normally. If the command terminates abnormally and you then restart the host,
the connection target of the shared disk might be changed to the standby node.
When the auto option is specified, the XP7 Command View AE Common Component and HiRDB
will be in the stopped state after the command is executed.
For these folders, specify absolute paths using no more than 63 bytes.
You can use the following characters to specify these folders:
A to Z, a to z, 0 to 9, ., _
You can also specify backslashes (\), colons (:), and forward slashes (/) as path delimiters. If the
auto option is specified, the command automatically stops XP7 Command View AE Common
Component and starts HiRDB. After command execution, both XP7 Command View AE Common
Component and HiRDB will not be running.
Troubleshooting128