HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 Administrator Guide

DetailsProperty
Specify whether to also link to an external authorization server.
Specify true to link to an external authorization server.
Specify false to not to link to an external authorization server.
Default value: false
auth.group.mapping
Table 35 Setup items in the exauth.properties file for LDAP authentication (when directly specifying
information about the external authentication server)
DetailsAttributes
Specify the protocol for connecting to the LDAP directory server. This attribute is
required.
When communicating in plain text format, specify ldap. When using StartTLS
communication, specify tls.
Before specifying tls, make sure that one of the following encryption methods
can be used on the LDAP directory server.
• TLS_RSA_WITH_AES_256_CBC_SHA
• TLS_RSA_WITH_AES_128_CBC_SHA
• SSL_RSA_WITH_3DES_EDE_CBC_SHA
Specifiable values: ldap or tls
Default value: none
protocol
#1
Specify the host name or IP address of the LDAP directory server. If you specify the
host name, make sure beforehand that the host name can be resolved to an IP
address. If you specify the IP address, you can use either an IPv4 or IPv6 address.
When specifying an IPv6 address, enclose it in square brackets ([]). This attribute
is required.
Default value: none
host
#2
Specify the port number of the LDAP directory server. Make sure beforehand that
the port you specify is set as the listen port number on the LDAP directory server.
Specifiable values: 1 to 65535
Default value: 389
port
Specify the amount of time to wait before timing out when connecting to the LDAP
directory server. If you specify 0, the system waits until a communication error
occurs without timing out.
Specifiable values: 0 to 120 (seconds)
Default value: 15
timeout
Administrator Guide 129