HP XP P9000 Command View Advanced Edition Suite Software 7.6.0-00 CLI Reference Guide

3. For each of the host storage domains (ordered as described in step 2), HostScan adds the
WWNs detected in step 1 into the host information.
The information is added for any host whose host name is the nickname of a host storage domain.
However, if a corresponding host is not registered, the host is registered with a host name identical
to a host storage domain nickname and then the information is added to the host information.
If the same WWN is assigned to multiple host storage domains, this processing is performed for
the first host storage domain only.
Format
To perform a host scan for the specified storage systems, use the following format:
hdvmcli [URL] HostScan [options]
serialnum=serial-number model=model
To perform a host scan for all storage systems, use the following format:
hdvmcli [URL] HostScan [options]
option=all
Parameters
Table 98 HostScan command parameters
DescriptionStatusParameter name
Parameter used to specify the serial numbers of the storage
systems for which a host scan is to be performed.
Use a comma to delimit multiple values.
Optional
#1, #2
serialnum
Parameter used to specify the models of the storage systems for
which a host scan is to be performed.
Use a comma to delimit multiple values.
Optional
#1, #2
model
Parameter used to perform a host scan for all storage systems.
The value you can specify is all, which is not case-sensitive.
Optional
#1
option
#1
Always specify either the serialnum and model parameters together, or option=all.
#2
To specify a storage system, both the serialnum and model parameters must be specified to-
gether. Make sure that both the order and values specified for serialnum and model are correct.
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
CLI Reference Guide 293