HP XP P9000 Command View Advanced Edition Suite Software 7.6.0-00 Administrator Guide (Web Version)

• Services and resource group that need to be removed from the cluster management: The manuals
for P9000 Command View AE Suite products.
• How to install P9000 Command View AE Suite: HP P9000 Command View Advanced Edition
Suite Software Installation and Configuration Guide
Installing on the standby node (new installation)
To perform a new installation of P9000 Command View AE Suite on the standby node:
1. Perform a new installation of P9000 Command View AE Suite on the standby node.
Preparations for installation are as follows:
• Specify the same installation location as the one specified on the executing node.
• If a cluster environment has been configured for another P9000 Command View AE Suite
product, specify the logical host name for the management server's IP address (the virtual
host name assigned to the cluster management IP address). If a cluster environment has not
been configured for any other P9000 Command View AE Suite product, specify the host
name IP address of the standby node.
2. From the GUI, register licenses for the products you want to use.
Access the IP address of the standby node.
A license key must be entered for each product that is installed.
3. Use a text editor to create a cluster-configuration file.
If a cluster environment has been configured for another P9000 Command View AE Suite product,
there is no need to perform this step.
The items to be specified in the cluster-configuration file are as follows:
mode=standby
virtualhost=logical-host-name
onlinehost=executing-node-host-name
standbyhost=standby-node-host-name
Save the created file as cluster.conf in installation-folder-of-Common-Component\
conf.
CAUTION:
• Specify standby for mode.
• For virtualhost, onlinehost, and standbyhost, an IP address cannot be
specified. Also make sure that an IP address can be resolved from the host name.
• The IP address that is assigned to the logical host name specified in virtualhost
must be enabled and accessible.
4. Open the server.properties file and make sure that the logical host name is specified in
the server.http.host property.
If the logical host name is not set, change the current value to the logical host name.
installation-folder-of-the-Device-Manager-server\Server\config\
server.properties
Administrator Guide (Web Version) 171