HP StorageWorks P9000 Tiered Storage Manager Software 7.1 CLI Reference Guide (TB585-96011, May 2011)

The KATS50226-E and KATS50907-E messages are output.
CreateShreddingTask
The CreateShreddingTask command can be used to create a shredding task that erases all data
from a migration group. Shredding is performed for a migration group.
If the migration group contains volumes that cannot be shredded (such as locked volumes), the task
only erases data from shreddable volumes. You can move the shredded volumes to another migration
group.
If any of the following conditions exists, you cannot create a shredding task:
• When there is no volume that can be shredded in a migration group specified for the migration-
groupname parameter
• The migration group specified for the movetomigrationgroupname parameter at the creation
of a task is specified for the migrationgroupname parameter in a task that has not ended (End)
• When any of the conditions that prevent you from creating a task described in “Creating and
executing tasks” on page 118 is met
After volumes have been completely shredded, the data is gone and you can move the shredded
volumes to another migration group. This enables you to set aside volumes without any data to be
used again later.
Syntax
htsmcli [ server-location] CreateShreddingTask
[ common-option ]
[ { -f | --force } ]
[ { -e | --execute } ]
storagedomainname=storage-domain-name
migrationgroupname=migration-group-name
[ shreddingmethod={ ZERO-ONCE | DoD } ]
[ movetomigrationgroupname=name-of-target-migration-group-after-shredding ]
[ notifytourl=event-notification-address ]
[ description=task-description ]
Options
-f or --force
Specify this option to create a shredding task without confirmation.
If this option is omitted, it will be necessary to confirm task creation.
-e or --execute
Specify this option to execute the created shredding task immediately.
If this option is omitted, the shredding task will be placed in Standby status.
Parameters
Table 54 Parameters of the CreateShreddingTask command
DetailsParameter
Specify the name of the storage domain.
storagedomainname
CLI Reference Guide 131