HP StorageWorks P9000 Replication Manager Software 7.1 Configuration Guide (TB584-96022, May 2011)

these values. To change the values, you need expert knowledge of Device Manager Agent. The
following table describes the available properties and settings.
Table 36 List of properties in the agentif.properties File
DescriptionProperty
The amount of time Replication Manager waits to connect to a Device Manager
Agent when collecting copy pair statuses. If 0 is specified, Replication Manager
waits until a connection is established without timing out.
Specifiable values: 0 to 3600 (seconds)
Default value: 30
agentif.connect-
Timeout
The amount of time Replication Manager waits to receive a response from a
Device Manager Agent when collecting copy pair statuses. If 0 is specified,
Replication Manager waits for a response is without timing out.
Specifiable values: 0 to 86400 (seconds)
Default value: 3600
agentif.response-
Timeout
The amount of time Replication Manager waits to connect to a Device Manager
Agent when collecting configuration information or performing copy pair
operations. If 0 is specified, Replication Manager waits until a connection is
established without timing out.
Specifiable values: 0 to 3600 (seconds)
Default value: 30
hdvmagtif.connect-
Timeout
The amount of time Replication Manager waits to receive a response from a
Device Manager Agent when collecting configuration information or performing
copy pair operations. If 0 is specified, Replication Manager waits for a response
without timing out.
Specifiable values: 0 to 86400 (seconds)
Default value: 3600
hdvmagtif.response-
Timeout
The maximum number of times that Replication Manager checks the processing
status of a Device Manager Agent when Device Manager Agent takes an
indefinite period of time to collect configuration information or to perform copy
pair operations. If 0 is specified, Replication Manager can check the status an
unlimited number of times.
Specifiable values: 0 to 100 (times)
Default value: 50
hdvmagtif.MaxPolling-
Count
The interval at which Replication Manager checks the processing status of a
Device Manager Agent when Device Manager Agent takes an indefinite period
of time to collect configuration information or to perform copy pair operations.
Specifiable values: 5 to 1200 (seconds)
Default value: 30
hdvmagtif.PollingIn-
terval
Properties in the appagentif.properties file
The appagentif.properties file is used to specify the values of properties necessary for the
interface between Replication Manager and Application Agent. Normally, you do not need to change
Configuration Guide 79