HP StorageWorks P9000 Replication Manager Software 7.1 Configuration Guide (TB584-96022, May 2011)
Properties in the bcmif.properties file
The bcmif.properties file is used to specify the values of properties related to the interface
between Replication Manager and HP StorageWorks P9000 for Business Continuity Manager Software
or between Replication Manager and P9000 mainframe agent. The following table describes the
available properties and settings.
Table 35 List of properties in the bcmif.properties file
DescriptionProperty
The amount of time Replication Manager waits to read data from HP
StorageWorks P9000 for Business Continuity Manager Software or P9000
mainframe agent. If 0 is specified, Replication Manager waits until all data
is read without timing out.
Specifiable values: 0 to 86400 (seconds)
Default value: 3600
bcmif.socketTimeout
The amount of time Replication Manager waits to connect to HP
StorageWorks P9000 for Business Continuity Manager Software or P9000
mainframe agent. If 0 is specified, Replication Manager waits until a
connection is established without timing out.
Specifiable values: 0 to 3600 (seconds)
Default value: 5
bcmif.socketConnect-
Timeout
The retry interval when Replication Manager cannot establish a connection
with HP StorageWorks P9000 for Business Continuity Manager Software or
P9000 mainframe agent. If 0 is specified, Replication Manager will
continually attempt to establish a connection.
Specifiable values: 0 to 1800 (seconds)
Default value: 60
bcmif.ReconnectionInter-
val
The number of retries attempted when Replication Manager cannot establish
a connection with HP StorageWorks P9000 for Business Continuity Manager
Software or P9000 mainframe agent. If 0 is specified, the number of retries
is unlimited.
Specifiable values: 0 to 100 (times)
Default value: 5
bcmif.ReconnectionCount
Properties in the agentif.properties file
The agentif.properties file is used to specify the values of properties necessary for the interface
between Replication Manager and a Device Manager Agent. Normally, you do not need to change
Operating the management server78