HP StorageWorks P9000 Replication Manager Software 7.1 Configuration Guide (TB584-96022, May 2011)

Default value (unit)PropertyFile
30 (seconds)
hdvmagtif.connectTimeout
3600 (seconds)
hdvmagtif.responseTimeout
50 (times)
hdvmagtif.MaxPollingCount
30 (seconds)
hdvmagtif.PollingInterval
30 (seconds)
agentif.connectTimeout
agentif.properties
3600 (seconds)
agentif.responseTimeout
30 (seconds)
hdvmagtif.connectTimeout
3600 (seconds)
hdvmagtif.responseTimeout
50 (times)
hdvmagtif.MaxPollingCount
30 (seconds)
hdvmagtif.PollingInterval
30 (seconds)
appagentif.connectTimeout
appagentif.proper-
ties
3600 (seconds)
appagentif.responseTimeout
truebase.repositry.synchronize.polling
base.properties
120 (seconds)
base.taskscheck.interval
0 (times)
base.taskscheck.maxcount
120 (seconds)
base.taskscheck.mf.interval
0 (times)
base.taskscheck.mf.maxcount
truebase.alert.automarking
10 (minutes)
base.repositry.synchronize.interval
Properties in the logger.properties file
The logger.properties file is used to specify the values of log output-related properties. If a value
is not specified in the logger.properties file, or if the specified value is outside the specifiable
range, the default value will be used. The following table describes the available properties and
settings:
Table 32 List of properties in the logger.properties file
DescriptionProperty
The threshold value for the output level of the Replication Manager
log files. Messages containing values that are equal to or less than
this value are output to the log file.
Specifiable values: 0, 10, 20, 30 (in decreasing order of
importance from left to right).
Default value: 20
logger.loglevel
Configuration Guide 73