HP StorageWorks P9000 Replication Manager Software 7.1 Configuration Guide (TB584-96022, May 2011)

KAPM06441-I The HiRDB service has already stopped.
Changing settings in the properties files
This section describes the settings in the properties files used by Replication Manager and how to
change them.
Use a text editor to alter parameters in the properties files. After making changes, you must do the
following:
• Restart Replication Manager. To do this, you must first stop and then start the services. For details,
see “Starting and stopping Replication Manager” on page 69.
• In a cluster environment, the values in the properties files of the executing and standby nodes must
match. (If you change a properties file on the executing node, you must do the same for the standby
node.)
NOTE:
Inappropriate changes to properties files can have unexpected results. HP recommends that you
use the default values unless they cause problems.
Properties related to Replication Manager
The properties required by Replication Manager are specified in the following properties files stored
on the management server:
• logger.properties
• serverstorageif.properties
• bcmif.properties
• agentif.properties
• appagentif.properties
• base.properties
These files are in the following directory.
installation-folder-for-P9000-Replication-Manager\conf
The following table lists the properties and default values for each file.
NOTE:
Under normal circumstances, the agentif.properties properties do not need to be changed.
To change their values, you need expert knowledge of Device Manager Agent.
Table 31 List of Replication Manager properties
Default value (unit)PropertyFile
20
logger.loglevel
logger.properties
0
logger.sysloglevel
Configuration Guide 71