HP StorageWorks P9000 Replication Manager Software 7.1 CLI Reference Guide (TB584-96021, May 2011)

• When restoring Information Stores, if you specify both an Information Store and a storage
group of the same storage group, an error will occur.
• When restoring Information Stores, if you specify a storage group and an Information Store
of different storage groups, the backup data is restored as storage groups and Information
Stores respectively.
• If you specify an Information Store of data other than backup data obtained by using VSS, an
error will occur.
• If you specify storage-group-name\, an error will occur.
• When you want to specify an Information Store name, check the value displayed in INFORM-
ATIONSTORE of the drmexgcat command and specify exactly the same Information Store
name.
• At restoration, this command dismounts all Information Stores within the storage group to which
the specified Information Store belongs.
• If the restoration target drive contains Information Store files that are not restoration targets,
an error will occur.
• If the restoration target drive contains data from different storage groups, an error will occur.
• If ONLINE is set in CLU_MSCS_RESTORE in the Application Agent configuration definition file
(init.conf), restoration can be performed while the cluster resources are online.
Return Values
0: Normal termination
Any value other than 0: Termination with an error
Conditions Causing an Error
This extended command fails in the following cases:
• An invalid option is specified.
• The system cannot acquire information from the operation definition file linked to the operation
ID.
• A specified Application Agent command option cannot be specified as an extended command
option.
• The system fails to record a backup ID in the backup ID record file.
• A command executed inside the extended command encounters an error.
• The command fails to obtain the name of the directory where dictionary map files are stored.
Examples
• In this example, the extended command is used to restore data from the secondary volume to the
primary volume by resynchronizing the volumes, based on the settings specified in the operation
definition file operation01:
EX_DRM_EXG_RESTORE operation01 -resync
• In this example, the extended command is used to restore Information Store IS12 of storage group
SG1, based on the settings specified in the operation definition file operation01:
EX_DRM_EXG_RESTORE operation01 -resync -recovery -target SG1\IS12
CLI Reference Guide 75