HP StorageWorks P9000 Replication Manager Software 7.1 CLI Reference Guide (TB584-96021, May 2011)

-force
Specify this option to restore the data from the secondary volume to the primary volume by forcibly
resynchronizing the volumes.
With this option, forced resynchronization is performed if the copy group name of the primary volume
obtained when backup processing was performed on the database server matches the information
on the database server, even though the LDEV and SERIAL numbers do not match the LDEV and SERIAL
numbers when backup processing was performed.
Specify this option only if restoration by resynchronization could not be performed with the -resync
option, such as when the LDEV number changes when the volume is replaced. If this option is specified
under a normal restoration, data might be corrupted.
-recovery
Specifies that a recovery will be executed by rolling forward. When the command is executed,
post-backup transactions are recovered, and the database is returned to the latest status. However,
this is only true if from the time that the backup was acquired until the time that the command was
executed, everything was stored properly in Exchange Server.
If this option is omitted, the database will return to the status it was in when the backup was acquired.
This option is essential if you want to restore backup data that was obtained using VSS in units of
Information Stores when using Exchange Server 2003 or Exchange Server 2007. If you have specified
an Information Store name in the -target option or -f option and you have not specified the
-recovery option, this command terminates with an error. However, if all Information Store names
within the storage group that is the restoration target have been specified, you can restore backup
data even without specifying the -recovery option.
If the -recovery option is not used to restore a backup obtained by cold backup, the -recovery
option cannot be used for backups obtained after the restored cold backup.
-pf copy-parameter-definition-file
Specify this option when using the number of retries and the retry interval defined in the copy parameter
definition file. Specify only the file name, without specifying the path.
When you omit this option, the value of the RAID Manager-linkage definition file (DEFAULT.dat) is
used. The value of the RAID Manager-linkage definition file (DEFAULT.dat) is used for parameters
that are not coded in the copy parameter definition file.
Create the copy parameter definition file with an arbitrary name in the location below. Specify the
file name by using an alphanumeric character string that is 64 bytes or less.
Application-Agent-installation-directory\DRM\conf\raid
-vf VSS-definition-file-name
This option specifies the VSS definition file used at VSS backup. You can use this option only when
restoring backup data that was obtained using VSS. If you specify this option when restoring data
other than backup data obtained using VSS, it will be ignored.
For VSS-definition-file-name, specify a file name only. Do not specify the folder name. The
VSS definition file specified in this option must be stored in the following folder:
Application-Agent-installation-directory\DRM\conf\vss
If you omit this option, the command uses the following file as the VSS definition file:
Application-Agent-installation-directory\DRM\conf\vsscom.conf
For details about the VSS definition file, see the HP StorageWorks P9000 Replication Manager
Software CLI User Guide.
Basic commands210