HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 CLI Reference Guide (TB581-96066, September 2011)

DescriptionStatusParameter name
Serial number of the storage system that contains the S-VOL
If you specify this parameter, specify either svolserialnum or
svolsequencenum. Do not specify both parameters at the same
time. If they are specified at the same time, an error will occur.
Optional
svolserialnum
#
Sequence number of the storage system that contains the S-VOL
If you specify this parameter, specify either svolserialnum or
svolsequencenum. Do not specify both parameters at the same
time. If they are specified at the same time, an error will occur.
Optional
svolsequen-
cenum
#
Device number of the S-VOL
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200 or XP1024/XP128,
use the xx:yy format, where xx is the CU number, and yy is
the LDEV number. For P9500 or XP24000/XP20000, use the
ww:xx:yy format, where ww is the LDKC number, xx is the CU
number, and yy is the LDEV number. ww is optional. If you omit
ww, the LDKC number is regarded as 0.
The execution results are output in decimal.
Optional
svoldevnum
#
Copy pace
You can specify an integer from 1 to 15.
When changing the copy pace for an identified copy pair, specify
the parameters pvolserialnum, pvoldevnum,
svolserialnum, and svoldevnum. When using one operation
to change the copy paces of all copy pairs, omit these parameters.
If split or resync is specified for the operation parameter,
this parameter will be ignored.
If the type of operation that is to be executed with the copy pair
is Snapshot or Continuous Access Journal Software, this parameter
will be ignored.
Optional
copytracksize
#
To manipulate a specific copy pair in a copy group, the pvolserialnum, pvoldevnum,
svolserialnum (or svolsequencenum), and svoldevnum parameters must all be specified.
If you omit all of these parameters, the system deletes all copy pairs in the specified copy group.
Parameter values to obtain in advance
replicationgroupid, pvolserialnum, pvoldevnum, svolserialnum, and svoldevnum:
Obtain the values of these parameters from the execution result of the GetHost command. Specify
the value of replicationGroupID that is displayed as An instance of ReplicationGroup
in the replicationgroupid parameter, the value of pvolSerialNumber that is displayed as An
instance of ReplicationInfo in the pvolserialnum parameter, the value of pvolDevNum
in the pvoldevnum parameter, the value of svolSerialNumber in the svolserialnum parameter,
and the value of svolDevNum in the svoldevnum parameter.
svolsequencenum: Obtain the parameter value from the execution result of the GetStorageArray
command for the storage system that contains the S-VOL. Specify the value of sequenceNumber
that is displayed as An instance of StorageArray in the svolsequencenum parameter.
Command reference280