HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 CLI Reference Guide (TB581-96066, September 2011)

displayMasterStartDevNum=00:00
masterEndDevNum=16,383
displayMasterEndDevNum=3F:FF
remoteArrayFamily=XP12K/10K/SVS200
remoteArrayType=Unknown
remoteSerialNumber=14050
remoteSSID=0
remoteControllerID=0
remotePathGroupID=165
remoteStartDevNum=-1
remoteEndDevNum=-1
pairType=0
bandwidth=-1
numOfMinConnection=1
.
. (repeated for other ReplicationControllerPair instances)
.
*****: The value is encoded by the CLI.
ModifyReplication
The ModifyReplication command is used to change the status of a copy pair.
Parameters
Table 104 ModifyReplication command parameters
DescriptionStatusParameter name
Number of the copy groupRequired
replication-
groupid
Specify one of the following values:
• split: Split the copy pair.
• resync: Re-synchronize the copy pair from the primary
volume (P-VOL) to the secondary volume (S-VOL).
• restore: Re-synchronize the copy pair from the S-VOL to the
P-VOL.
Required
operation
Serial number of the storage system that contains the P-VOLOptional
pvolserialnum
#
Device number of the P-VOL
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200 and XP1024/XP128,
use the xx:yy format, where xx is the CU number, and yy is
the LDEV number. For P9500 and XP24000/XP20000, use the
ww:xx:yy format, where ww is the LDKC number, xx is the CU
number, and yy is the LDEV number. ww is optional. If you omit
ww, the LDKC number is regarded as 0.
The execution results are output in decimal.
Optional
pvoldevnum
#
CLI Reference Guide 279