HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 CLI Reference Guide (TB581-96066, September 2011)

NOTE:
• This command is not available for XP1024/XP128.
• To delete a specific copy pair from a copy group, you must specify pvolserialnum,
pvoldevnum, svolserialnum (or svolsequencenum), and svoldevnum. If you omit all
of these parameters, the system deletes all copy pairs in the specified copy group.
Parameters
Table 102 DeleteReplication command parameters
DescriptionStatusParameter name
Number of the copy groupRequired
replication-
groupid
Serial number of the storage system that contains the primary
volume (P-VOL)
Optional
pvolserialnum
Device number of the P-VOL
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200, use the xx:yy format,
where xx is the CU number, and yy is the LDEV number. For
P9500 and XP24000/XP20000, use the ww:xx:yy format,
where ww is the LDKC number, xx is the CU number, and yy is
the LDEV number. ww is optional. If you omit ww, the LDKC number
is regarded as 0.
The execution results are output in decimal.
Optional
pvoldevnum
Serial number of the storage system that contains the S-VOL
If you specify this parameter, specify either svolserialnum or
svolsequencenum. Do not specify both parameters at the same
time. If they are specified at the same time, an error will occur.
Optional
svolserialnum
Sequence number of the storage system that contains the S-VOL
If you specify this parameter, specify either svolserialnum or
svolsequencenum. Do not specify both parameters at the same
time. If they are specified at the same time, an error will occur.
Optional
svolsequen-
cenum
Device number of the S-VOL
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200, use the xx:yy format,
where xx is the CU number, and yy is the LDEV number. For
P9500 and XP24000/XP20000, use the ww:xx:yy format,
where ww is the LDKC number, xx is the CU number, and yy is
the LDEV number. ww is optional. If you omit ww, the LDKC number
is regarded as 0.
The execution results are output in decimal.
Optional
svoldevnum
Command reference274