HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

Parameters
Table 30 AddVirtualVolume command parameters
DescriptionStatusParameter name
Serial number of the storage systemRequired
serialnum
Model of the storage systemRequired
model
Specifies whether to create THP volumes within an existing virtual
parity group.
Specify exist to create the THP volumes in an existing virtual
parity group.
If you specify this parameter, you must also specify the
arraygroupname parameter.
Optional
(XP24000/XP20000)
groupoption
Name of a virtual parity group
Use the format Xn-1 (where n is a numeric character) to specify
the virtual parity group name.
You must specify this parameter if you specify exist in the
groupoption parameter.
Optional
(XP24000/XP20000)
arraygroupname
Capacity of THP/Smart volumes (KB).
You can specify the following values:
For P9500:
You can use the capacitytype parameter to change the
unit of capacity to blocks.
- 48000 to 64424505600 (in KB)
- 96000 to 128849011200 (in blocks)
For XP24000/XP20000:
You can use the capacitytype parameter to change the
unit of capacity to blocks.
If the microcode version is earlier than 60-03:
- 48000 to 3221159680 (in KB)
- 96000 to 6442319360 (in blocks)
If the microcode version is 60-03 or later:
- 48000 to 4294967296 (in KB)
- 96000 to 8589934592 (in blocks)
Required
capacity
Number of THP/Smart volumes
Specify the number of THP/Smart volumes to be created.
If this parameter is omitted, 1 is set.
Optional
numoflus
Device number of the logical unit
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
If this parameter is omitted, it is set automatically.
Optional
devnum
CLI Reference Guide 91