HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

nickname=Jane
An instance of WWN
WWN=11.33.22.33.44.33.22.22
nickname=Jone
An instance of WWN
WWN=55.66.77.88.44.33.22.22
nickname=
*****: The values are encoded by the CLI.
ModifyPortController
ModifyPortController supports changing characteristics of a PortController.
NOTE:
This command can be used only with XP24000/XP20000, XP12000/XP10000/SVS200, and
XP1024/XP128.
Parameters
Table 72 ModifyPortController command parameters
DescriptionStatusParameter name
Serial number of the port controller's storage systemRequired
serialnum
Model of the port controller's storage systemRequired
model
Number of the port controller
Specify either ctrlid or controllername. Do not specify
both parameters at the same time. If they are specified at the
same time, an error will occur.
Optional
ctrlid
Port controller name
Specify either ctrlid or controllername. Do not specify
both parameters at the same time. If they are specified at the
same time, an error will occur.
Optional
controllername
Mode value of the port controller
Specify either of the following values:
• 1: Normal
• 2: High Speed
Required
adaptermode
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
ctrlid
Command reference208