HP P9000 Command View Advanced Edition Suite Software 7.2 CLI Reference Guide

userID=root
]
[An instance of StorageArray
.
. (Attributes of StorageArray are omitted here)
.
List of 1 CommParameters elements:
An instance of CommParameters
ipAddress=172.16.40.1
]
.
. (repeated for other StorageArray instances)
.
RunZeroPageReclaim
RunZeroPageReclaim performs a zero-page reclaim operation, which returns unused capacity in
THP volumes (virtual volumes).
Zero-page reclaim can be performed for THP volumes that satisfy either of the following conditions:
• The volumes do not constitute a copy pair.
• The volumes constitute a copy pair that was created by either Continuous Access Software or
Continuous Access Journal Software.
You can use the GetZeroPageReclaimStatus command to check whether a zero-page reclaim
operation has finished.
NOTE:
This command can be used only with P9500 and XP24000/XP20000. The microcode version required
for XP24000/XP20000 is 60-07-00-XX/XX or later.
Parameters
Table 74 RunZeroPageReclaim Command Parameters
DescriptionStatusParameter Name
Serial number of the storage systemRequired
serialnum
Model of the storage systemRequired
model
Device number(s) of THP volume(s)
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Required
devnums
Parameter values to obtain in advance
serialnum and model
CLI Reference Guide 207