LSF Version 7.3 - Platform LSF Configuration Reference

function: Gethostbyaddr_(<host>/<port>) failed: error
main: Request from unknown host <host>/<port>: error
function: Received request from non-LSF host <host>/<port>
The daemon does not recognize host as a Platform LSF host. The request is not serviced. These
messages can occur if host was added to the configuration files, but not all the daemons have
been reconfigured to read the new information. If the problem still occurs after reconfiguring
all the daemons, check whether the host is a multi-addressed host. See Administering Platform
LSF for information about working with multi-addressed hosts.
rcvLoadVector: Sender (<host>/<port>) may have different config?
MasterRegister: Sender (host) may have different config?
LIM detected inconsistent configuration information with the sending LIM. Run the following
command so that all the LIMs have the same configuration information.
lsadmin reconfig
Note any hosts that failed to be contacted.
rcvLoadVector: Got load from client-only host <host>/<port>. Kill LIM
on <host>/<port>
A LIM is running on a Platform LSF client host. Run the following command, or go to the
client host and kill the LIM daemon.
lsadmin limshutdown host
saveIndx: Unknown index name <name> from ELIM
LIM received an external load index name that is not defined in the lsf.shared file. If name
is defined in lsf.shared, reconfigure the LIM. Otherwise, add name to the lsf.shared
file and reconfigure all the LIMs.
saveIndx: ELIM over-riding value of index <name>
This is a warning message. The ELIM sent a value for one of the built-in index names. LIM
uses the value from ELIM in place of the value obtained from the kernel.
getusr: Protocol error numIndx not read (cc=num): error
getusr: Protocol error on index number (cc=num): error
Protocol error between ELIM and LIM. See Administering Platform LSF for a description of
the ELIM and LIM protocols.
RES messages
These messages are logged by the RES.
doacceptconn: getpwnam(<username>@<host>/<port>) failed: error
doacceptconn: User <username> has uid <uid1> on client host <host>/
<port>, uid <uid2> on RES host; assume bad user authRequest: username/
uid <userName>/<uid>@<host>/<port> does not exist
authRequest: Submitter’s name <clname>@<clhost> is different from
name <lname> on this host
Troubleshooting and error messages
604 Platform LSF Configuration Reference