HP XC System Software Hardware Preparation Guide Version 4.0

Table 4-22 BIOS Settings for HP ProLiant DL145 G3 Nodes (continued)
Set to This ValueOption NameSubmenu NameMenu Name
Enabled
32-Bit Memory Hole
Enabled
Embedded SATASerial ATA
SATA
SATA Mode
Enabled
Enabled/Disable Int13
support
Enabled
Option ROM Scan
Enabled
Enable Master
0040h
Latency Timer
On-board COM A
Com Port AddressConsole Redirection
115.2K
Baud Rate
ANSI
Console Type
None
Flow Control
Direct
Console connection
On
Continue C.R. after POST
1
# of video pages to support
DHCP
IP Address AssignmentIPMI/LAN Setting
NIC
LAN Controller:
Disabled
HPET Timer
Disabled
8042 Emulation Support
Disabled
Factory Boot Mode
Set the following boot order on
all nodes except the head node:
1. Removable Devices
2. CD-ROM Drive
3. MBA v9.0.6 Slot 0820
4. Hard Drive
5. MBA v9.0.6 Slot 0821
Set the following boot order on
the head node:
1. Removable Devices
2. CD-ROM Drive
3. Hard Drive
Boot
4. Select Exit→Saving Changes to exit the BIOS Setup Utility.
5. Repeat this procedure for each HP ProLiant DL145 G2 and DL145 G3 node in the hardware
configuration.
4.7.2 Preparing HP ProLiant DL165 G5 Nodes
Use the BIOS Setup utility on HP ProLiant DL165 G5 servers to configure the appropriate settings
for an HP XC system.
For this hardware model, you cannot set or modify the default console port password through
the BIOS Setup Utility the way you can for other hardware models. The HP XC System Software
Installation Guide documents the procedure to modify the console port password. You are
90 Preparing Individual Nodes