HP XC System Software Hardware Preparation Guide Version 4.0

Figure 4-19 HP ProLiant DL385 G5p Server Rear View
The callouts in the figure enumerate the following:
1. This port is the Ethernet connection to the Console Switch. On the back of the node, this
port is marked with the acronym iLO.
2. This port is the connection to the Administration Switch (branch or root). On the back of the
node, this port is marked with the number 1.
3. If a Gigabit Ethernet (GigE) interconnect is configured, this port is used for the interconnect
connection. Otherwise, it is used for an external connection. On the back of the node, this
port is marked with the number 2.
Setup Procedure
Perform the following procedure from the iLO Setup Utility for each HP ProLiant DL385 G5p
node in the hardware configuration:
1. Use the instructions in the accompanying hardware documentation to connect a monitor,
mouse, and keyboard to the node.
2. Turn on power to the node. Watch the screen carefully during the power-on self-test, and
press the F8 key when prompted to access the Integrated Lights Out Setup Utility.
3. Make the following iLO settings for each DL385 G5p node, as shown in Table 4-34:
4.7 Preparing the Hardware for CP4000 (AMD Opteron) Systems 105