HP XC System Software Administration Guide Version 4.0

NOTE:
Ensure that the sendmail utility is running. For information on the implementation of the
sendmail utility on the HP XC system, see “Modifying Sendmail” (page 133).
You can customize the Nagios configuration to specify whom to contact by editing the /opt/
hptc/nagios/etc/contacts.cfg file. The main portion of this file is shown here:
# 'nagios' contact definition
define contact{
contact_name nagios
alias Nagios Admin
service_notification_period 24x7
host_notification_period 24x7
service_notification_options w,u,c,r
host_notification_options d,u,r
service_notification_commands notify-by-email,notify-by-epager
host_notification_commands host-notify-by-email,host-notify-by-epager
email [e-mail]
pager [e-mail]
}
Changing the values for email and pager to reflect your system's name enables Nagios to send
notification through the sendmail utility. For example, changing
[e-mail] to [e-mail].
NOTE: Nagios can generate many e-mail messages. You can use the open source Nan utility
to help control these messages. For more information, see “Using the Nan Notification Aggregator
and Delimiter To Control Nagios Messages” (page 127).
8.3.4 Changing Sensor Thresholds
Job loads, usage patterns, process types, counts, memory, cache, disk subsystems, and so on all
contribute input to Nagios. Nagios uses threshold values to determine whether or not to send
an alert, and, if so, whether that alert is critical or a warning. Nagios monitors the sensor thresholds
and generates alerts when a threshold is reached. Depending on your specific site configuration
and use, some default thresholds might not be appropriate for your system.
The platform-dependent default thresholds provided in the HP XC system serve as a baseline,
but they might not be optimal for your site. As system administrator, you need to determine the
threshold values appropriate for your site and customize the Nagios configuration.
The /opt/hptc/nagios/etc/nagios_vars.ini file represents various constants and
variables used throughout the HP XC system's plug-ins and the Nagios configurations. You can
edit this file to customize Nagios for the thresholds. Changing these values changes when Nagios
alerts you to subsystems encountering thresholds.
The nagios_vars.ini file also contains variables that are commented out. Examine the content
of the file to determine if those variables are appropriate for your system. If so, remove the
comment characters accordingly. This portion of the nagios_vars.ini file is an example:
# Note any sensors matched by the following patterns will
# be individually archived and viewable via shownode metrics sensors
# any sensors not matched will be reported as a single group
# status when it is within threshold. Any sensor reporting
# outside of its thresholds will always be individually archived.
# SENSORPRINT0 = CPU[0-9]+ TEMP
# SENSORPRINT1 = SYS TEMP
Perform the following steps if you modify the nagios_vars.ini file so that your changes take
effect:
1. Use the editor of your choice to edit the /opt/hptc/nagios/etc/nagios_vars.ini
file.
8.3 Adjusting the Nagios Configuration 117