HP XC System Software Release Notes for Version 3.2.1

5.4.3 Benign RRDtool Message On c3000 Enclosures With a Nortel switch
The following warning might be displayed during cluster_config processing on a c3000
Enclosure that has a Nortel switch:
Executing C52xcgraph gconfigure
WARNING - "rrdtool returned ERROR: you must define at least one Data Source
In this release, Nortel switches are not monitored by the RRD framework, so you can safely
ignore this message.
5.5 Notes that Apply to Imaging
The notes in this section apply to propagating the golden image to all nodes, which is
accomplished when you invoke the startsys command.
5.5.1 HP ProLiant DL145 G3 Node Imaging Fails When Graphics Cards Are Present
As described in “Discovery of HP ProLiant DL145 G3 Nodes Fails When Graphics Cards Are
Present” (page 24), the discovery and imaging processes might fail on HP ProLiant DL145 G3
servers containing graphics cards.
The work around for the discovery failure is described in “Discovery of HP ProLiant DL145 G3
Nodes Fails When Graphics Cards Are Present” (page 24), and the work around for the imaging
process described in this section assumes that all nodes were discovered.
Follow this procedure to propagate the golden image to DL145 G3 servers containing a graphics
card:
1. Issue the appropriate startsys command and specify one of the DL145 G3 nodes with a
graphics card in the [nodelist] option of the startsyscommand.
2. When power to the node is turned on, use the cluster console to connect to the node and
force it to PXE boot by pressing the F12 key at the appropriate time during the BIOS start
up.
3. When the node is successfully imaged, repeat this process for the remaining nodes containing
graphics cards.
4. When all nodes containing graphics cards are imaged, issue the startsys command without
the [nodelist] option to image all remaining nodes of the cluster in parallel.
26 System Discovery, Configuration, and Imaging