HP XC System Software Release Notes for Version 3.2.1

In the previous example, --maxnodes= specifies the total
number of nodes in the hardware configuration, including
the planned nodes. For example, if the current hardware
configuration contains 100 nodes, and you plan to add 96
compute nodes in the future, --maxnodes=196.
--single The --single option was added to the enclosure based
discover command. This new option must be included
on the command line when the hardware configuration
contains only one HP BladeSystem model c3000 or model
c7000 enclosure.
When you are discovering a configuration with only a
single enclosure, the discover command prompts you
to supply the MAC address of the Onboard Administrator
instead of supplying the MAC address of the ProCurve
switch.
1.6 Documentation Changes
All manuals in the HP XC System Software Documentation Set have been reissued for this release:
• HP XC System Software Release Notes
• HP XC Hardware Preparation Guide
• HP XC System Software Installation Guide
• HP XC System Software Administration Guide
• HP XC System Software User's Guide
• Master Firmware List
All documents, but especially the HP XC System Software Release Notes , are updated periodically
on the worldwide web to make sure the most up to date information is available. Therefore, HP
recommends that frequently visit http://www.docs.hp.com/en/linuxhpc.html and make sure you
have the latest version of all documents because they might have been updated since the last
time you downloaded them.
HP XC HowTos On the Worldwide Web
HP XC information that is published between releases is issued in HowTo documents at the
following website:
http://www.docs.hp.com/en/linuxhpc.html
Scalable Visual Array Patch Kit Documentation
The SVA Release Notes for SVA Patch Kit Release Version 2.1.1 are available at the following
website:
http://www.docs.hp.com/en/linuxhpc.html
1.6 Documentation Changes 15