HP XC System Software Release Notes for Version 3.1

qsctrl: QR0N00:00:0:3 <--> Elan:0:3 state 3 should be 4
qsctrl: QR0N00:00:1:0 <--> Elan:0:4 state 3 should be 4
qsctrl: QR0N00:00:1:1 <--> Elan:0:5 state 3 should be 4
qsctrl: QR0N00:00:1:2 <--> Elan:0:6 state 3 should be 4
qsctrl: QR0N00:00:1:3 <--> Elan:0:7 state 3 should be 4
qsctrl: QR0N00:00:2:0 <--> Elan:0:8 state 3 should be 4
qsctrl: QR0N00:00:2:1 <--> Elan:0:9 state 3 should be 4
qsctrl: QR0N00:00:2:2 <--> Elan:0:10 state 3 should be 4
qsctrl: QR0N00:00:2:3 <--> Elan:0:11 state 3 should be 4
qsctrl: QR0N00:00:3:0 <--> Elan:0:12 state 3 should be 4
qsctrl: QR0N00:00:3:1 <--> Elan:0:13 state 3 should be 4
qsctrl: QR0N00:00:3:2 <--> Elan:0:14 state 3 should be 4
qsctrl: QR0N00:00:3:3 <--> Elan:0:15 state 3 should be 4
qsctrl: QR0N00:01:0:0 <--> Elan:0:16 state 3 should be 4
qsctrl: QR0N00:01:0:1 <--> Elan:0:17 state 3 should be 4
qsctrl: QR0N00:01:0:2 <--> Elan:0:18 state 3 should be 4
qsctrl: QR0N00:01:0:3 <--> Elan:0:19 state 3 should be 4
qsctrl: Warning: failed link state check on 1 modules
To work around this issue, configure out the unconnected links using the qsctrl -o command.
For example,
# qsctrl -o QR0N00:00:0:0
# qsctrl -o QR0N00:00:0:1
# qsctrl -o QR0N00:00:0:2
NOTE: You must only configure out links where the ELAN connections are identified with the
Elan designator in the destination field. For example,
qsctrl: QR0N00:02:3:3 <--> Elan:0:47 link state normal
Links that have the QR0Nxx designator in both the origin and destination field must not be
configured out. Doing so will cause the whole chip to go into reset. For example, do not configure
out the link if it looks as follows
qsctrl: QR0N00:04:0:3 <--> QR0N00:03:7:4 link state reset
If you attach nodes to any of these ports, you must configure them back in again before the link
can be used. For example:
# qsctrl -i QR0N00:00:0:0
5.11 OVP qsnet_database Test May Fail Due to Benign Errors Returned By the qsctrl Utility 47