HP XC System Software Installation Guide Version 3.2.1
Executing C50supermond gconfigure
Executing C51nagios_monitor gconfigure
Executing C60nis gconfigure
Executing C51nagios_monitor gconfigure
Executing C52snmp_traps gconfigure
Configuring the snmptrapd service for the cluster.
SNMP traps are configured to be received over the following interfaces:
loopback
Admin
Snmptrapd is also configured to listen to the Nagios IP alias.
Enter any additional interfaces over which SNMP traps are to be received:
1) External
2) Interconnect
Use a space-separated list to specify multiple interfaces, for example, 1 2
or enter 'd' if you want to start again with the (d)efault configuration
or leave blank if you want to use the current configuration:
Interfaces over which traps will be accepted:
loopback
Admin
[O]k, [R]especify Interfaces: O
11. Provide information about SVA and the remote graphics software configuration if you
installed the SVA or remote graphics software:
Executing C52sva_stuff gconfigure
Does this cluster have a KVM attached to the visualization nodes (y/n)?
You must now specify the display nodes for the cluster.
Enter the host name of the first display node.
You can enter names like n[1-4] or n[1,3] too
n[1-5]
Enter the host name of the next display node
leave blank if you have no more display nodes:
You must now specify the Remote Graphics nodes for the cluster.
Each Remote Graphics node must have an external ethernet address configured.
Enter the host name of the first Remote Graphics node.
You can enter names like n[1-4] or n[1,3] too
n1
Enter the host name of the next Remote Graphics node
leave blank if you have no more Remote Graphics nodes:
The following configuration questions are specific to HP RGS:
Do you want to use the RGS sender on the head node (y/n)? [n]
You have installed RGS Sender 4.0.0. Will you be using
RGS Receiver 3.0 to connect this cluster (y/n)? [n]
12. Configure a self-signed certificate for the Apache server. This step is optional, but if you do
not configure a self-signed certificate, the certificate that is shipped with the Linux base
operating system will be used instead.
Executing C52xcgraph gconfigure
Executing C54httpd gconfigure
Would you like to create a self-signed certificate for the Apache server? [y]/n Enter
You are about to be asked to enter information that will be incorporated
into your certificate request.
What you are about to enter is what is called a Distinguished Name or a DN.
There are quite a few fields but you can leave some blank
For some fields there will be a default value,
If you enter '.', the field will be left blank.
-----
Country Name (2 letter code) [GB]:
State or Province Name (full name) [Berkshire]:
Locality Name (eg, city) [Newbury]:
Organization Name (eg, company) [My Company Ltd]:
Organizational Unit Name (eg, section) []:
Common Name (eg, your name or your server's hostname) []:
Email Address []:
A self-signed certificate has been created for this cluster
3.11 Task 10: Respond to Configuration Questions 95