HP XC System Software Installation Guide Version 3.2.1

info: Executing C90munge cconfigure
info: Executing C90slurm cconfigure
info: Executing C95lsf cconfigure
info: nconfig shut down
info: nconfig started
info: Executing on head node
info: Executing C02network nrestart
info: Executing C03nicbond nrestart
info: Executing C04ip6tables nrestart
info: Executing C04iptables nrestart
info: Executing C06nfs_server nrestart
info: Executing C08ntp nrestart
info: Executing C10hptc_cluster_fs nrestart
info: Executing C10hptc_cluster_fs_client nrestart
info: Executing C12dbserver nrestart
info: Executing C20gmmon nrestart
info: Executing C20smartd nrestart
info: Executing C30syslogng_forward nrestart
info: Executing C35dhcp nrestart
info: Executing C40hpasm nrestart
info: Executing C50cmf nrestart
info: Executing C50collectl nrestart
info: Executing C50gather_data nrestart
info: Executing C50hptc-lm nrestart
info: Executing C50lvs nrestart
info: Executing C50nagios nrestart
info: Executing C50nat nrestart
info: Executing C50supermond nrestart
info: Executing C51nagios_monitor nrestart
info: Executing C51nrpe nrestart
info: Executing C52snmp_traps nrestart
info: Executing C60nis nrestart
info: Executing C66ibmon nrestart
info: Executing C90slurm nrestart
info: Executing C91swmlogger nrestart
info: Executing C95lsf nrestart
info: Executing C30syslogng_forward crestart
info: Executing C35dhcp crestart
info: Executing C50cmf crestart
info: Executing C50supermond crestart
info: Executing C60nis crestart
info: Executing C90munge crestart
info: Executing C90slurm crestart
info: Executing C95lsf crestart
info: nconfig shut down
NOTE: If necessary, see “Troubleshooting the Imaging Process” (page 160) for information
about using the imaging log files to troubleshoot the imaging process.
Proceed to “Task 12: Run the startsys Utility to Start the System and Propagate the Golden Image”.
3.12 Task 11: Edit the /etc/dhcpd.conf File
This task is optional. Perform this task only if the system is using a Myrinet interconnect and
you followed the instructions in “Configure Myrinet Switch Monitoring Line Cards” (page 184)
and saved a backup copy of the /etc/dhcpd.conf file:
1. Use the text editor of you choice to open the /etc/dhcpd.conf file.
2. In another terminal window, use the text editor of your choice to open the
/etc/dhcpd.conf.ORIG file.
3. Merge the customizations in the backup copy of the file into the /etc/dhcpd.conf file.
3.12 Task 11: Edit the /etc/dhcpd.conf File 101