HP XC System Software Installation Guide Version 3.2

8. Enable web access to the Nagios monitoring application and create a password for the
nagiosadmin user. This password does not have to match any other password on the
system. In this example, the Nagios service has been configured with improved availability.
Executing C50nagios gconfigure
Availability can be configured for nagios in one of several ways.
The choices are:
1: standard
2: serviceguard
A choice of 'standard' (1) means no improved availability.
Enter the number corresponding to the way to configure availability []: 2
Would you like to enable web based monitoring? ([y]/n) y
Enter the password for the 'nagiosadmin' web user:
New password: your_nagios_password
Re-type new password: your_nagios_password
Adding password for user nagiosadmin
Executing C50nat gconfigure
9. Provide an additional external IP address to use as an external alias if you configured
improved availability for the NAT service:
Availability can be configured for nat in one of several ways.
The choices are:
1: standard
2: serviceguard
A choice of 'standard' (1) means no improved availability.
Enter the number corresponding to the way to configure availability []: 2
Please provide the external IP alias for server n16 []: IP_address
Please provide the external IP alias for server n14 []: IP_address
10. Specify how you want to configure the snmptrapd service if the hardware configuration
includes HP server blade enclosures or if you have defined an mcs.ini file to configure
MCS devices.
Enclosures and MCS devices are connected to the administration network, so accept the
default responses of Admin and loopback .
Enter the letter R to specify External and Interconnect if the system is configured with
additional SNMP-based devices that are connected to either the external or interconnect
networks but are not connected to the administration network.
Executing C50supermond gconfigure
Executing C51nagios_monitor gconfigure
Executing C60nis gconfigure
Executing C51nagios_monitor gconfigure
Executing C52snmp_traps gconfigure
Configuring the snmptrapd service for the cluster.
SNMP traps are configured to be received over the following interfaces:
loopback
Admin
Snmptrapd is also configured to listen to the Nagios IP alias.
Enter any additional interfaces over which SNMP traps are to be received:
1) External
2) Interconnect
Use a space-separated list to specify multiple interfaces, for example, 1 2
or enter 'd' if you want to start again with the (d)efault configuration
or leave blank if you want to use the current configuration:
Interfaces over which traps will be accepted:
loopback
Admin
[O]k, [R]especify Interfaces: O
11. Provide information about SVA and the remote graphics software configuration if you
installed the SVA or remote graphics software:
Executing C52sva_stuff gconfigure
Does this cluster have a KVM attached to the visualization nodes (y/n)?
You must now specify the display nodes for the cluster.
3.11 Task 10: Respond to Configuration Questions 93