HP XC System Software Installation Guide Version 3.2

New password confirmed.
Lights-Out> exit
• For BMC Firmware Version 1.24 or higher:
a. Press Esc and Shift-9 to enter into the command-line mode.
b. Change to the following directory:
/directory_name/-> cd map1/accounts
c. List the pre-defined users (by default, 16 users have been pre-defined):
/directory_name/-> show
d. One user at a time, use the show command until you find the first instance of the
user name admin . Start with user1 and continue executing the show command
for each user in sequential order:
/directory_name/-> show user1
/directory_name/-> show user2 {...userN}
For the purposes of this example, assume that user3 is the first instance of the
user name admin .
e. Change directory to the user directory obtained in the previous step:
/directory_name/-> cd user3
f. Set the password. Be very careful with your key strokes; there is no password
verification step:
/directory_name/-> set password=your_password
g. Exit from the interface:
/directory_name/-> exit
4. Repeat this procedure to change the console management device password on every HP
ProLiant DL140 and DL145 node in the hardware configuration.
5. Rerun the discover command with the same options.
3.7 Task 6: Set Up the System Environment
Table 3-4 lists the tasks that are required to set up the system environment. Perform these tasks
now before the system is configured so that the information is propagated to the appropriate
client nodes during the initial image synchronization.
Some tasks are required and other tasks are conditionally optional, as listed in Table 3-4.
Table 3-4 System Environment Setup Tasks
Conditionally Optional TasksRequired Tasks
“Install Additional Software From HP or Third-Party
Vendors” (page 77)
“Put the License Key File in the Correct Location
(Required)” (page 75)
“Create the /hptc_cluster File System ” (page 81)“Configure Interconnect Switch Monitoring Line Cards
(Required)” (page 75)
“Modify Workstation Model Names in the Database”
(page 81)
“Configure sendmail (Required)” (page 75)
“Enable Software RAID-0 or RAID-1 on Client Nodes”
(page 81)
“Customize the Nagios Environment (Required)”
(page 77)
“Create Local User Accounts ” (page 82)“Configure Access to the Console Port on the Head Node
(Required)” (page 77)
“Override Default User and Group Account IDs”
(page 82)
“Set the BMC Password on HP Integrity Systems
(Required)” (page 77)
“Customize Client Node Disk Partitioning” (page 83)
74 Configuring and Imaging the System