HP XC System Software Installation Guide Version 3.2

checking 172.31.16.1
checking 172.31.16.4
checking 172.31.16.3
checking 172.31.16.2 .done
Starting CMF for discover...
Stopping cmfd: [FAILED]
1
Starting cmfd: [ OK ]
Waiting for CMF to establish console connections .......... done
uploading database
Restarting dhcpd
Opening /etc/hosts
Opening /etc/hosts.new.XC
Opening /etc/powerd.conf
Building /etc/powerd.conf ... done
Attempting to start hpls power daemon ... done
Waiting for power daemon ... done
uploading database
1
The discover command turns off the console management facility (CMF) daemon.
If the CMF daemon is not running, a “FAILED” message is displayed. This message
is expected, and you can ignore it.
6. Do one of the following:
• Proceed to “Modify the Default Password for HP ProLiant DL140 and DL145 Hardware
Models” if the hardware configuration contains HP ProLiant DL140 and DL145 hardware
models.
• Proceed to “Task 6: Set Up the System Environment” (page 74) if the hardware
configuration does not contain HP ProLiant DL140 and DL145 hardware models.
3.6.3 Modify the Default Password for HP ProLiant DL140 and DL145 Hardware
Models
Perform this task only if the hardware configuration contains HP ProLiant DL140 and DL145
hardware models (G2 and G3) to modify the default console management device password.
Changing the default password is not required, but HP recommends changing the factory default
value for security purposes. Omit this step for all other server models.
1. Use the method of your choice to view the /etc/dhcpd.conf file and look for the characters
cp- in host names to determine console port names.
2. Use the telnet command and the internal name of the console port to log in to each node's
console management device and change the default password. Supply the factory default
user name admin and the default password admin to log in:
# telnet cp-node_name
login: admin
password: admin
3. The interface you use to change the password differs depending upon the BMC firmware
version. Thus, do one of the following:
• For BMC Firmware Version 1.03:
a. Press Esc and Shift-9 to enter the command-line mode.
b. Use the C[hange Password] option to change the console port password. The
factory default password is admin; change it to the password of your choice. This
password must be the same on every node in your system.
Lights-Out> C
Type the current password> admin
Type the new password (max 16 characters)> your_password
Retype the new password (max 16 characters)> your_password
3.6 Task 5: Run the discover Command to Discover Hardware Components 73