HP XC System Software Installation Guide Version 3.2

switchName necs1-1 switchIP 172.20.65.2 type 2650
switchName nems1-1 switchIP 172.20.65.1 type 2848
Attempting to power on nodes with nodestring 8n[13-15]
Powering on all known nodes ... done
Discovering Nodes...
running port_discover on 172.20.65.1
nodes Found = 1 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 1 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 1 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 1 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 3 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 3 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 3 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 3 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 3 nodes Expected = 4
running port_discover on 172.20.65.1
nodes Found = 4 nodes Expected = 4
All nodes initialized.
Powering off all nodes but head node ... done
Switch 172.20.65.1 port 42 ... Node Found
Switch 172.20.65.1 port 41 ... Node Found
Switch 172.20.65.1 port 40 ... Node Found
Switch 172.20.65.1 port 39 ... Node Found
Switch 172.20.65.1 port 38 ... NO Node Found
5
Restarting dhcpd
node n14 set to model ProLiant DL145 G1
node n13 set to model ProLiant DL145 G2
node n15 set to model ProLiant DL145 G1
node n16 set to model ProLiant DL585 G1
Opening /etc/hosts
Opening /etc/hosts.new.XC
Head Node CP device type set to iLO
Waiting for power daemon to restart... done
1
Enter the MAC address of the switch that is connected to the administration ports.
Do not enter the MAC address of the switch connected to the console ports.
2
Enter the password for the Root Administration Switch that you previously defined
when you prepared the hardware. If you did not preset a password, press the Enter
key.
3
Enter the common user name and password that you previously defined for the
console port management devices (the iLO, LO-100i, or MP devices) when you
prepared the hardware. If you did not predefine these items, press the Enter key.
4
If the discover process hangs while trying to discover console ports, see Chapter 12
(page 165).
5
This is expected behavior. Because this is a cluster discovery process, the command
output No Switch Found or No Node Found is expected. This message does
not indicate a failure unless a network component is plugged into that port on the
switch.
3.6 Task 5: Run the discover Command to Discover Hardware Components 69