HP XC System Software Installation Guide Version 3.2

Here is the output from the command:
n[3-16] 14 lsf idle
Checking for non-idle node states.
+++ PASSED +++
Verify LSF:
Testing identification ...
Starting the command:
/opt/hptc/lsf/top/6.2/linux2.6-glibc2.3-ia64-slurm/bin/lsid
Here is the output from the command:
Platform LSF HPC 6.2 for SLURM, May 10 2006
Copyright 1992-2005 Platform Computing Corporation
My cluster name is hptclsf
My master name is lsfhost.localdomain
Checking output from command.
+++ PASSED +++
Testing hosts_static_resource_info ...
Running 'lshosts -w'.
Checking output from lshosts.
Running 'controllsf show' to determine virtual hostname.
Checking output from controllsf.
Virtual hostname is lsfhost.localdomain
Comparing ncpus from Lsf lshosts to Slurm cpu count.
The Lsf and Slurm cpu count are in sync.
+++ PASSED +++
Testing hosts_status ...
Running 'bhosts -w'.
Checking output from bhosts.
Running 'controllsf show' to determine virtual hostname.
Checking output from controllsf.
Virtual hostname is lsfhost.localdomain
Comparing MAX job slots from Lsf bhosts to Slurm cpu count.
The Lsf MAX job slots and Slurm cpu count are in sync.
+++ PASSED +++
Verify interconnect:
Testing infiniband/monitoring_line_card_setup ...
+++ PASSED +++
Testing infiniband/port_state ...
Collecting vstat data from all enabled nodes...
Nodes with a good port_state of PORT_ACTIVE: n[3-16]
+++ PASSED +++
Verify nagios:
Testing configuration ...
Running basic sanity check on the Nagios configuration file.
Starting the command:
/opt/hptc/bin/nagios -v /opt/hptc/nagios/etc/nagios_local.cfg
Here is the output from the command:
233