HP XC System Software Installation Guide Version 3.2

12. Compare the final LSF configuration with the saved version to ensure that only the
appropriate changes relevant to the upgrade have occurred. Also ensure (or restore, if
required) the elim scripts.
HP recommends that you use another terminal window to install the elim scripts at the
point when the cluster_config utility displays the following prompt:
All user specified configuration is complete.
The Golden Image will be created next.
[P]roceed, [Q]uit:
Thus, changes to the /opt/hptc/lsf/top/6.2/ directory will be included in the golden
image. This is the directory where elim scripts are expected to reside.
Any changes to the LSF configuration files in the /hptc_cluster/lsf/conf/ directory
can occur after cluster_config has finished because this directory is not part of the
golden image.
If the LSF version has changed, binary paths (including the $LSF_SERVERDIR directory,
where elim scripts are expected to reside) have also changed.
13. Re-enter the monitoring line card entries in the /etc/dhcpd.conf file if the system is using
a Myrinet interconnect. See “Configure Myrinet Switch Monitoring Line Cards” (page 194)
for more information about adding entries to this file.
Omit this step if the system is using an InfiniBand, QsNet
II
, or Gigabit Ethernet interconnect.
Proceed to “Task 9: Image and Boot the System and Start Compute Resources.”
5.10 Task 9: Image and Boot the System and Start Compute Resources
Follow this procedure to image and boot all nodes and start LSF:
1. Use the startsys command to turn on power to all nodes, image the nodes, and boot the
nodes.
The command-line options for the initial system image and boot are listed in Table 5-8 and
depend on the number of nodes, whether or not the hardware configuration contains HP
server blades and enclosures, and the size of the disks.
5.10 Task 9: Image and Boot the System and Start Compute Resources 129