HP XC System Software Installation Guide Version 3.0

info: Executing C51nrpe nconfigure
info: Executing C90munge nconfigure
info: Executing C90slurm nconfigure
info: Executing C95lsf nconfigure
info: Executing C30syslogng_forward cconfigure
info: Executing C35dhcp cconfigure
info: Executing C50supermond cconfigure
info: Executing C90munge cconfigure
info: Executing C90slurm cconfigure
info: Executing C95lsf cconfigure
info: nconfig shut down
info: nconfig started
info: Executing on head node
info: Executing C02network nrestart
info: Executing C04iptables nrestart
info: Executing C06nfs_server nrestart
info: Executing C08ntp nrestart
info: Executing C10hptc_cluster_fs nrestart
info: Executing C10hptc_cluster_fs_client nrestart
info: Executing C20gmmon nrestart
info: Executing C30swmlogger nrestart
info: Executing C30syslogng_forward nrestart
info: Executing C40hpasm nrestart
info: Executing C50cmf nrestart
info: Executing C50collectl nrestart
info: Executing C50gather_data nrestart
info: Executing C50hptc-lm nrestart
info: Executing C50nagios nrestart
info: Executing C50nat nrestart
info: Executing C50supermond nrestart
info: Executing C51nagios_monitor nrestart
info: Executing C51nrpe nrestart
info: Executing C90munge nrestart
info: Executing C90slurm nrestart
info: Executing C95lsf nrestart
info: Executing C30syslogng_forward crestart
info: Executing C35dhcp crestart
info: Executing C50supermond crestart
info: Executing C90munge crestart
info: Executing C90slurm crestart
info: Executing C95lsf crestart
info: nconfig shut down
Note
If necessary, see “Troubleshooting the Imaging Process” (page 144) for information about using the
imaging log files to troubleshoot the imaging process.
Proceed to “Task 8: Modify SLURM Characteristics (Optional)” to modify the SLURM configuration file. This
task is optional.
Task 8: Modify SLURM Characteristics (Optional)
The /hptc_cluster/slurm/etc/slurm.conf SLURM configuration file is created with a minimum
understanding of the characteristics of the nodes in the system.
The spconfig command configures the processor and memory configuration for all of the compute nodes
in the slurm.conf file. You can configure other compute node characteristics such as compute node
Task 8: Modify SLURM Characteristics (Optional) 59