HP XC System Software Installation Guide Version 3.0

running port_discover on 172.20.65.1
nodes Found = 6 nodes Expected = 6
All nodes initialized.
Powering off all nodes but head node ... done
Switch 172.20.65.1 port 22 ... Node Found
Switch 172.20.65.1 port 21 ... Node Found
Switch 172.20.65.1 port 20 ... Node Found
Switch 172.20.65.1 port 19 ... Node Found
Switch 172.20.65.1 port 18 ... Node Found
Switch 172.20.65.1 port 17 ... Node Found
Switch 172.20.65.1 port 16 ... NO Node Found
4
Restarting dhcpd
node n11 set to model ProLiant DL140 G2
node n12 set to model ProLiant DL140 G2
node n16 set to model ProLiant DL380 G4
node n14 set to model ProLiant DL360 G4
node n13 set to model ProLiant DL360 G4
node n15 set to model ProLiant DL380 G4
Opening /etc/hosts
Opening /etc/hosts.new.XC
Head Node CP device type set to iLO
Waiting for power daemon to restart... done
1
Enter the MAC address of the switch that is connected to the administration ports. Do not
enter the MAC address of the switch connected to the console ports.
2
Enter the password for the Root Administration Switch that you previously defined when you
prepared the hardware. If you did not preset a password, press the Enter key.
3
Enter the common user name and password that you previously defined for the console port
management devices (the iLO, LO-100i, or MP devices) when you prepared the hardware.
If you did not predefine these items, press the Enter key.
4
This is expected behavior. Because this is a cluster discovery process, the command output
No Switch Found or No Node Found is expected. This message does not indicate a
failure unless a network component is plugged into that port on the switch.
If necessary, see Appendix K: Troubleshooting (page 141) for information about troubleshooting
problems you may encounter during the discovery process.
Note
The following prompts are displayed for large-scale systems:
The discover process has detected 2 regions. Is this correct? [y/n] y
switchName nems0-1-0 switchIP 172.20.65.1 type 2848
Enter the actual total number of nodes in region 1: 526
Enter the number of nodes that are workstations: 0
Enter the actual total number of nodes in region 2: 504
Enter the number of nodes that are workstations: 0
discoverSystem called with switch nems1-1-1 and Region Number 1
5. If you captured the output of the discover command in a file (described in step 2), press Ctrl+d to
end the script now.
This file is for your information only; store this file in a directory where you keep administrative data.
6. Do the following on HP XC systems with HP ProLiant DL140 G2 and DL145 G2 nodes; otherwise, skip
this step for all other server models:
44 Configuring and Imaging the System