HP XC System Software Hardware Preparation Guide Version 3.2

Figure 4-15 xw9300 Workstation Rear View
1
The callout in the figure enumerates the following:
1. This port is used for the connection to the administration network.
Figure 4-16 shows a rear view of the xw9400 workstation and the appropriate port connections
for an HP XC system.
Figure 4-16 xw9400 Workstation Rear View
2
1
The callouts in the figure enumerate the following:
1. If a Gigabit Ethernet (GigE) interconnect is configured, this port is used for the interconnect
connection. Otherwise, it is used for an external connection.
2. This port is used for the connection to the administration network.
Setup Procedure
Use the Setup Utility to configure the appropriate settings for an HP XC system.
Perform the following procedure for each workstation in the hardware configuration. Change
only the values described in this procedure; do not change any other factory-set values unless
you are instructed to do so:
1. Use the instructions in the accompanying hardware documentation to connect a monitor,
mouse, and keyboard to the node and establish a connection to the console.
4.7 Preparing the Hardware for CP4000 (AMD Opteron) Systems 85