HP XC System Software Release Notes for Version 2.1

duplicate LABELS
2. It is not currently possible to determine the device to select at installation
time. The SAN volume is shown twice in the list of devices; it may appear as
/dev/sdb and /dev/sdc (the exact device names depend on the number of
SCSI hard disks in the system). During the installation, select a device, and if
the installation process is unable to use it, restart the installation and select
the other device.
3. When the installation is complete, in order to connect the second HBA port to
the SAN switch (either physically or virtually, that is, presented through the
SAN Appliance GUI), you must edit the /etc/fstab file.
To do so, determine the partitions that correspond to the labels in the
/etc/fstab file (the first column in the entries in that file will contain either
a partition name, such as /dev/sdb1, or a label identifier, such as LABEL=/1).
To determine the partition names corresponding to the label identifiers, use
the findfs command for each label identifier in the /etc/fstab file. For
example, to determine the partition that corresponds to LABEL=/1, enter the
following command:
# findfs LABEL=/1
4. When you have identified the label identifiers and partitions, edit the
/etc/fstab file (make sure to save a backup copy) and replace all of the label
identifiers with the corresponding partition names. Save your changes to the
file. Then, connect the second HBA port, and reboot the system.
11-2 Cluster Platform 6000 Notes